Omron GRT1 - 27-11-2006 Operation Manual page 38

Installing the GRT1-PRT Unit
Note
Connecting the End
Unit
Installing the End
Plates
Note
Turnback Cable connectors
GRT1-TBR Turnback Unit
(for right side of block)
The Turnback Units can be used to divide a SmartSlice I/O System into up to
three blocks.
A GRT1-END End Unit must be connected at the end of the SmartSlice I/O
System.
GRT1-END End Unit
Always secure the SmartSlice I/O System on the DIN Rail by installing End
Plates on both sides of the System. First hook the bottom of the End Plate on
the bottom edge of the DIN Rail (1), attach the top of the End Plate, and pull
the End Plate down onto the top edge of the DIN Rail (2). Tighten the End
Plate's securing screw.
End Plate
OMRON GRT1-PRT
RUN RUN UNIT PWR UNIT PWR
5 5
ERR ERR
0 0
BF BF
x10 x10 x1 x1
TS TS I/O PWR I/O PWR
ON ON
BUS BUS
1 REGS REGS
2 NC NC
3 ADR ADR
4 BACK BACK
+V +V
-V
+V +V
-V -V
DC24V DC24V
INPUT INPUT
Always secure the SmartSlice I/O System by attaching End Plates on both
ends.
GRT1-TBL Turnback Unit
(for left side of block)
End Unit
Section 2-2
2
1
End Plate
19