Services And Addresses - Omron G3PW - MANUAL 2 User Manual

Services and Addresses

6-4

Services and Addresses

FINS-mini Command
Services
Addresses
Variable Type CE/8E (Monitor Level Parameters)
Address Data
0000 Input Monitor
0001 Duty Monitor
0002 Output Monitor
0003 Phase Angle Monitor
0004 Current Monitor
0005 Total Run Time Monitor
0006 Status
0007 Not used.
0008 Not used.
0009 Not used.
0010 Not used.
0011 Not used.
0012 Not used.
0013 Not used.
0014 Version
76
MRC SRC Service
01 01 Variable Area Read
01 02 Variable Area Write
05 03 Controller Attribute Read Reads the model number and communica-
06 01 Controller Status Read
08 01 Echo-back Test
30 05 Operation Command
Note Service requests will not be accepted and no response will be re-
turned if there is a RAM error or the Controller is in standby status.
(Standby status exists from when power is turned ON until normal
operation is possible.)
Data range
H'00000000 to H'000003E8
H'00000000 to H'000003E8
H'00000000 to H'000003E8
H'00000000 to H'000003E8
H'00000000 to H'000002EE
H'00000000 to H'000003E7
H'00000000 to H'00000***
Always 0.
Always 0.
Always 0.
Always 0.
Always 0.
Always 0.
Always 0.
H'00000000 to H'00000***
* The data ranges apply to all models of the G3PW.
Reads data from the variable area.
Writes data to the variable area.
tions buffer size of the Controller.
Reads operating status.
Performs an echo-back test.
Performs operation commands, such as
resetting and changing areas.
*
Notation
The data range is ten times
the actual values.
Bit fields
0
0
0
0
0
0
0
1.23 = 00000123
Section 6-4
Description