Omron G3PW - MANUAL 2 User Manual page 111

Parameters Set in Initial Setting Level
Display Name
p15
Total Run Time
Exceeded Alarm
Operation
p16
Total Run Time Alarm
Set Value
p17
External Input Range
Alarm Operation
p18
External Duty Input
Alarm Operation
p19
Communications Unit
*1
Number
p20
Communications
Baud Rate
p21
Communications
Data Length
p22
Communications
*1
Stop Bits
p23
Communications Par-
*1
ity
p24
Send Wait Time
p25
Communications
Main Setting Num-
*1
ber
p26
Communications Tim-
eout Time
p27
Reset Total Run Time Used to reset the total run time.
p28
Initialize Set Values
*1
Constant-current Models only.
96
Sets the alarm level to use when the total run time exceeds the set value.
0: Disable (Default)
1: Alarm level 1 (fatal error)
2: Alarm level 2 (nonfatal error)
An alarm is output when the total run time exceeds the set value.
*1
0.0 to 99.9 kh
0.0: This function stops when the parameter is set to 0.0. (Default)
Sets the alarm level when an external variable resistor disconnection occurs or
when the 4 to 20-mA or 1 to 5-V input range is exceeded.
0: Disable (Default)
1: Alarm level 1 (fatal error)
2: Alarm level 2 (nonfatal error)
Sets the alarm level when an external duty variable resistor disconnection occurs
or when the 4 to 20-mA or 1 to 5-V input range is exceeded.
0: Disable (Default)
1: Alarm level 1 (fatal error)
2: Alarm level 2 (nonfatal error)
Sets the Communications unit number for CompoWay/F.
0 to 99 (Default: 1)
Sets the baud rate for CompoWay/F.
*1
9.6: 9.6 k bit/s
19.2: 19.2 k bit/s
38.4: 38.4 k bit/s
57.6: 57.6 k bit/s (Default)
Sets the data length for communications.
7: 7 bits (Default)
*1
8: 8 bits
Sets the number of stop bits for communications.
1: 1 bit
2: 2 bits (Default)
Sets the parity for communications.
non: None
evn: Even (Default)
odd: Odd
*1 Sets the send wait time.
0 to 99 ms (Default: 1)
Sets the MV input channel.
• Connection to an OMRON EJ1 Modular Temperature Controller
0: Automatic assignment (recommended) (Default)
1: CH1 control output (heating)
2: CH2 control output (heating)
3: CH3 control output (heating)
4: CH4 control output (heating)
• Connection to an OMRON PLC
1: CH1
0 to 999 s (Default: 10)
0: Communications timeout function disabled
*1
abt: Do not reset. (Default)
ini: Initialize.
Used to initialize parameter settings.
abt: Do not initialize. (Default)
ini: Initialize.
Setting
5: CH1 control output (cooling)
6: CH2 control output (cooling)
7: CH3 control output (cooling)
8: CH4 control output (cooling)
Appendix A