Omron G3PW - MANUAL 2 User Manual page 59

Setting Parameters in the Initial Setting Level
Parameter Settings Related to Auxiliary Inputs
Parameter
External Duty Input Enable/Disable
Input Digital Filter Time Constant
Main Setting Input Parameter Settings
Event Input 0 (No assignment)
Assignment
or
[P11]
1 (Control method
selection)
2 (Main setting
automatic/manual
selection)
44
Output mode
Proportional to
phase angle
(same as G3PX)
[P01]
[P03]
Event Input Assignment
No Assignment
[P11]
The following table shows the relationship between the parameters related to
inputting the main settings.
Main Setting 0 (Automatic)
Automatic/
Main setting input using
Manual
linear input or commu-
Default [P08]
nications.
1 (Manual)
Main setting input using
an external variable
resistor or using key
operation.
Event input
Open (Automatic)
Event input
Closed (Manual)
Proportional to Proportional
square voltage to voltage
Internal Duty only
or
[P01] = 0#
Set the Input Digital Filter
Time Constant.
0.0 to 100 ms
[P03] = 0.0#
Phase Control and Optimum
or
Cycle Control Selection
[P11] = 0#
[P11] = 1
To settings related to protective functions
0 (4 to 20 mA or 1 to
5 V)
1 (Communications)
---
---
0 (4 to 20 mA or 1 to
5 V)
1 (Communications)
---
---
Constant-
Optimum cycle
current control
control
Setting enabled by external variable resistor.
[P01] = 1
Main Setting
or
Automatic/Manual Selection
[P11] = 2
Main Setting Main Setting
Automatic Input Manual Input
Selection [P05] Selection [P06]
---
---
0 (External variable
resistor)
1 (Key input)
---
---
0 (External variable
resistor)
1 (Key input)
Section 4-6
ON/OFF control
#: Default
*: Setting disabled