Operation Command - Omron G3PW - MANUAL 2 User Manual

Operation Command

6-7

Operation Command

Command
Response
Operation Codes and
Related Information
Note
Response Codes
Response code
"1001" Command length too long
"1002" Command length too short
"1100" Parameter error
"2203" Operation error
"0000" Normal end
82
This command is used to start and stop operation, save the manipulated vari-
able, execute a software reset, or initialize settings.
Operation
Related
SRC
code
information
MRC
"30" "05"
2 2 2
SRC
MRC Response code
"30" "05"
2 2 4
Operation
code
"06" Software Reset
"07" Setting Level Change (See note 1.)
"09" Main Setting Automatic/Manual Selec-
tion (See note 2.)
"0A" Control Method Selection (See note 3.) 00: Phase control
"0B" Parameter Initialization (See note 4.)
"0C" Error Reset
"0D" Total Time Initialization (See note 4.)
"0F" Pause (See note 5.)
(1) Execute a software reset to go from Initial Setting Level to Monitor Level.
(2) To use operation code 09, switching between automatic and manual for
the main setting must not be assigned to an event input (i.e., [P11] must
not be set to 2). Always set [P11] to 0 before using this operation code.
An operation error will occur if [P11] is set to 0.
(3) To use operation code 0A, switching the control method not be assigned
to an event input (i.e., [P11] must not be set to 1). Always set [P11] to 0
before using this operation code. An operation error will occur if [P11] is
set to 0.
(4) Parameters and the total time can be initialized only in Initial Setting Lev-
el.
(5) Execute an error reset to release the pause.
Error name
The command is too long.
The command is too short.
The operation code or related information is not correct.
An error occurred in nonvolatile memory.
Processing was completed normally.
Example: The following command executes a software reset.
Command: [STX]0100030050600[ETX][BCC]
Response: None
2
Operation
Cause
Section 6-7
Related information
Always 00.
00: Display level other than
Initial Setting Level
01: Display Initial Setting Level
00: Automatic
01: Manual
01: Optimum cycle control
Always 00.
Always 00.
Always 00.
Always 00.