Routine Maintenance Interval Table (Normal Worker); Daily Maintenance - Fimap EMX Use And Maintenance Manual

ROUTINE MAINTENANCE INTERVAL TABLE (NORMAL WORKER)

ROUTINE MAINTENANCE INTERVAL TABLE (NORMAL WORKER)
N.B.: "general worker" means someone able to handle tasks for which physical effort is required to carry out
specific but simple job-related procedures, or responsible for tasks or services calling for aptitude or for
knowledge that can be acquired in a few days.
N.B.: "specialised operator" means someone able to handle specific tasks requiring special practical skills
obtained via technical-practical preparation organised by FIMAP service centre technicians.

DAILY MAINTENANCE

DAILY MAINTENANCE
Reference Description
Clean squeegee rubber
blades
Clean squeegee suction
chamber
Clean the squeegee
nozzle
1
Clean the squeegee
suction hose
Clean the waste
collection tray present in
the recovery tank
Clean the suction motor
inlet air filter
Clean the brush (discoid
scrubbing version)
2A
Clean the splash guard
rubber blade (discoid
scrubbing version)
Clean the brush
(cylindrical scrubbing
version)
Clean the splash guard
2B
rubber blade (cylindrical
scrubbing version)
Clean the collection tray
(cylindrical scrubbing
version)
Clean the abrasive
2C pad (orbital scrubbing
version)
3 Empty the recovery tank
Clean the solution tank
4
filter - cap
Calculation
Clean the inner and outer surface of the
rubber blades present in the squeegee of the
machine
Clean the inner surface of the suction chamber
present in the squeegee body of the machine
Clean the inner surface of the suction nozzle
present in the squeegee body of the machine
Clean the inside of the suction hose that
connects the squeegee to the recovery tank
Clean the waste tray of any dirt or fouling, the
tray is inside the recovery tank
Clean the inlet air filter of any impurities or
fouling, the filter is located inside the recovery
tank
Remove impurities and waste from the bristles,
clean the bristles under a jet of water
Clean the inner and outer surface of the splash
guard rubber blade
Remove impurities and waste from the bristles,
clean the bristles under a jet of water
Clean the inner and outer surface of the side
splash guard rubber blade
Clean the inside of the collection box from any
dirt or fouling, the box is located at the rear of
the brush head tunnel
Clean the abrasive surface of the pad
Using the drain hose, empty the recovery tank
Clean the water system filter of any dirt or
fouling, the cap - filter located at the rear of the
machine
- 90 -
Paragraph
"CLEANING THE SQUEEGEE" on page 94
"CLEANING THE SQUEEGEE VACUUM
HOSE" on page 95
"RECOVERY TANK CLEANING" on page 96
"CLEANING OF THE SUCTION MOTOR
AIR INTAKE FILTER" on page 97
"CLEANING OF BRUSH HEAD DRIVE
BRUSH (DISCOID SCRUBBING
VERSION)" on page 98
"CLEANING BRUSH HEAD SPLASH
GUARD (DISCOID SCRUBBING
VERSION)" on page 101
"CLEANING BRUSH (CYLINDRICAL
SCRUBBING VERSION)" on page 102
"CLEANING BRUSH HEAD SPLASH
GUARD (CYLINDRICAL SCRUBBING
VERSION)" on page 102
"CLEANING DEBRIS HOPPER
(CYLINDRICAL SCRUBBING VERSION)"
on page 103
"CLEANING ABRASIVE PAD (ORBITAL
VERSIONS)" on page 104
"DRAINING THE RECOVERY TANK" on
page 96
"CLEANING THE SOLUTION TANK
FILTER-CAP" on page 105