Firmware; Labeling; Accessories - Elatec TWN4 MultiTech 2 Series User Manual

3.3

FIRMWARE

Your product is delivered ex-works with a specific firmware version, which is displayed on the
product label.
3.4

LABELING

The RFID readers and modules of the TWN4 MultiTech 2 family are delivered ex-works with a label (Fig.
1) attached on the rear side of the housing or directly on the module.
This label contains important product information (e.g. certification information) and may not be
removed or damaged. In case of a label wear-out, contact ELATEC.
In addition, once an RFID module has been integrated into a host device, the label might not be visible
anymore. In this case, specific requirements related to the labeling of the host device might apply. For
more information, refer to the integration manual of your RFID module and to the documentation
related to the host device.
3.5

ACCESSORIES

The RFID readers and modules of the TWN4 MultiTech 2 family ca be delivered with the following
optional components:
© 2024 – ELATEC GmbH – TWN4 MultiTech 2 family – user manual – DocRev01 – EN – 05/2024
Fig. 1 - exemplary illustration
Bracket holder
The bracket holder is a simple solution for attaching an RFID
desktop reader to a flat surface. It consists of one ground plate
and two brackets with screws and a double-sided strong
adhesive pad. For optional additional screwing, an extra hole is
located on the base plate.
Snap-in holder
The snap-in holder is another solution for attaching an RFID
desktop reader to a flat surface. It can be fixed with either
adhesive pads or screws.
TWN4 MultiTech 2 panel housing
The TWN4 MultiTech 2 panel housing is available as a kit
containing an IP65 plastic housing that can be used to install any
RFID module of the TWN4 MultiTech 2 family outside.
Page 14 of 60