Twn4 Multitech 2 Legic M Lf Hf - Elatec TWN4 MultiTech 2 Series User Manual

6.7.6 UNITED KINGDOM
TWN4 MultiTech 2 LEGIC M complies with the requirements of the UK legislations and other
regulations as listed in the respective UK declaration of conformity. The importer is responsible for
applying the following information to the packaging of the product:
•
the importer company's details, including the company's name and a contact
address in the United Kingdom.
•
UKCA marking
6.8

TWN4 MULTITECH 2 LEGIC M LF HF

6.8.1 EU
Hereby, ELATEC GmbH declares that TWN4 MultiTech 2 LEGIC M LF HF complies with Directive
2014/53/EU. The full text of the EU declaration of conformity is available at the following internet
address: elatec.com/approvals
6.8.2 FCC
FCC ID: WP5TWN4F22
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation. (except receivers associated with operation of a licensed radio service and stand-alone
devices).
Caution
The Federal Communications Commission (FCC) warns the users that changes or modifications to the
unit not expressly approved by the party responsible for compliance could void the user's authority to
operate the equipment.
FCC §15.105 (b)
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV technician for help.
© 2024 – ELATEC GmbH – TWN4 MultiTech 2 family – user manual – DocRev01 – EN – 05/2024 Page 36 of 60