Qualified Personnel; Safety Precautions - Danfoss iC7-Marine PROFINET Operating Manual

Operating Guide | iC7-Marine PROFINET
ISO warning symbol for hot surfaces and burn hazard
ISO warning symbol for high voltage and electrical shock
ISO action symbol for referring to the instructions

Qualified Personnel

1.4
Correct and reliable transport, storage, installation, operation, and maintenance are required for the trouble-free and safe operation of
the product. Only qualified personnel are allowed to install and operate this equipment.
Qualified personnel are defined as trained staff, who are authorized to install, commission, and maintain equipment, systems, and
circuits in accordance with pertinent laws and regulations. Also, the qualified personnel must be familiar with the instructions and safety
measures described in this guide.

Safety Precautions

1.5
HIGH VOLTAGE
Drives and power converters contain high voltage when connected to AC mains input, DC supply, or load
sharing. Failure to perform installation, start-up, and maintenance by qualified personnel can result in death or
serious injury.
Only qualified personnel are allowed to perform installation, start-up, and maintenance.
l
UNINTENDED START
When the drive or power converter is connected to the AC mains or connected on the DC terminals, the motor may start at any
time, causing risk of death, serious injury, and equipment or property damage.
Stop the drive or power converter before configuring parameters.
l
Make sure that the drive or power converter cannot be started by an external switch, a fieldbus command, an input reference
l
signal from the control panel, or after a cleared fault condition.
Disconnect the drive or power converter from the mains whenever safety considerations make it necessary to avoid
l
unintended motor start.
Check that the drive or power converter and any driven equipment are in operational readiness.
l
6
| Danfoss Drives Oy © 2024.04
WARNING
WARNING
AQ481922043454en-000101 / 172K4282A