Setting; Selecting Memory; Advanced Setting - Eighteeth CuringPen User Manual

6.Setting

6.1 Selecting memory mode

6.2 Advanced setting

6 Setting
Memory mode change
There are 6 built-in memory programs, namely M0,
M1, M2, RAMP, PULSE, Detect. Press setting key
to change the memory during standby state.
Light intensity setting
The memory modes of M0, M1 and M2 can be
customized to 2300mW/cm
. Long Press "S" to enter the light
2
1000mW/cm
intensity setting menu, then press "S" to change or
press main switch to confirm and exit.
On the light intensity setting menu, long press "S"
to enter the curing time setting menu.

The light intensity of RAMP, PULSE and
Detect memory modes are built-in, and
the user cannot modify the settings.
Curing Time setting
In the curing time setting menu, press "S" to select
different times. The time selection is different under
different light intensity:
light
intensity(mW/cm² )
2300
1500
1000
600
Long press "S" or short press
interface. The current memory mode automatically
saves the setting parameters.
In power off state, holding down press "S"
then press
setting.
It can be set to 1min, 5min, 10min or
15min.
Press
enter the next setting- "Volume" setting
mode.
2
, 1500mW/cm
time selection(sec)
01,02,03
05,10,15,20
05,10,15,20
10,15,20,25
to exit the setting
to enter the "Auto Off"
to change setting, press "S" to
2
or
Page 11 / 28