5
TROUBLESHOOTING, CARE AND MAINTENANCE
5.1
General Instructions
⚠
WARNING
+
Do not make any improper changes to the equipment.
+
To maintain the safety level of the equipment, it must be checked regularly for damage and
wear - especially on the foot straps, fasteners, handle hoses and seat.
⚠
CAUTION
+
Damaged or worn components may aff ect your safety and the life of the equipment.
Therefore, immediately replace damaged or worn components. In such a case, contact the
contract partner. The equipment must not be used until it has been repaired. If necessary,
use only original spare parts.
ATTENTION
+
In addition to the instructions and recommendations for maintenance and care given here,
additional service and/or repair work may be necessary; this must only be carried out by
authorised service technicians.
5.2
Faults and Fault Diagnosis
The equipment undergoes regular quality controls during production. Nevertheless, faults or
malfunctions may occur. Frequently, individual parts are responsible for these disturbances, an
exchange is usually suffi cient. Please refer to the following overview for the most common errors and
how to correct them. If the equipment still does not function properly, contact your contract partner.
Fault
Heart rate is not
received
LCD error – software
error etc.
Cause
+
Sources of interference in
the room
+
unsuitable chest strap
+
Wrong position of chest
strap
+
Batteries empty
Console has no power
supply
Solution
+
Eliminate sources of interference
(e.g. mobile phones, loudspeakers,
WLAN, lawn mower and vacuum
cleaner robots ...)
+
Use a suitable chest strap (see
recommended accessories).
+
Reposition
chest
moisten electrodes
+
Changing batteries
+
Hold Reset to start the console again.
+
Start
the
console
disconnecting the power cable for
about 15 seconds.
+
Disconnect and connect again all
cable connections, see assembly
instructions.
+
Contact a service technician of your
contract partner.
strap
and/or
again
by
35
Need help?
Do you have a question about the ROW-X PLUS and is the answer not in the manual?