How To Display Navigational Data - Furuno FAR-2228-NXT Operator's Manual

1. OPERATIONAL OVERVIEW
Note 2: [4 WAVE DATA] can only be active at one radar at any time. If [4 WAVE
DATA] is turned [ON] at another radar in the same network, it is automatically
turned [OFF] at this radar.
5. Referring to the table above, select the appropriate setting, then press the ENTER
MARK key.
6. Close the menu.
Wave data display
You can view wave data when a PC with the wave analysis software installed is con-
nected to the same network as this radar. When [4 WAVE DATA] is set to [ON], the
wave data appears in the information box in a manner similar to that shown below.
For further details regarding the wave analysis data, see the operator’s manual (OMC-
36181) supplied with the wave analysis software.
1.46.2

How to display navigational data

1. Open the menu.
2. Select [7 INFORMATION BOX].
3. Select [3 DISPLAY NAV DATA].
4. Select [ON] to display navigational data, [OFF] to hide navigational data.
5. Close the menu.
1-88