Interswitch; How To Display Antenna Information - Furuno FAR-2228-NXT Operator's Manual

1.48

Interswitch

The interswitch of this radar uses an Ethernet to transfer video and control signals. A
digital signal transfers the video and control signals. You can connect up to four an-
tennas and four display units. Set radar display and antenna groups from the [ANTEN-
NA SELECT] display.
When you switch to a different antenna, the heading skew and timing adjustment (set
at installation) for that antenna are automatically applied.
The [ANTENNA] box at the upper left position shows current antenna selection.
1.48.1

How to display antenna information

1. Open the menu.
2. Select [9 INITIAL SETTINGS].
3. Select [3 SELECT ANTENNA]. The [SELECT ANTENNA] menu appears.
Note: You can also right-click the [ANTENNA] box to access this menu.
Note: For configurations with processors assigned as [DISP5]/[DISP6]/[DISP7]/
[DISP8] at installation, the processor unit automatically connects to the system as
[SLAVE] when first turned on. You can change this setting after the first connection.
See section 1.48.2.
1. OPERATIONAL OVERVIEW
1-91