User Settings - Furuno FAR-2228-NXT Operator's Manual

5. Select [2 DATE-TIME], then select [UTC] or [LOCAL] as appropriate.
• [UTC]: Date and time are displayed in UTC format.
• [LOCAL]: Date and time are shown with the local time offset applied.
If you selected [UTC], close the menu. If you selected [LOCAL], go to step 6.
6. Select [3 ADJUST LOCAL TIME].
7. Spin the scrollwheel, or use the number keys to input the desired offset.
The offset must be in 30 minute increments.
Note: Regarding input for [3 ADJUST LOCAL TIME], when using the number
keys, the indication is first selected as a whole. At this time, you can toggle be-
tween plus “+” or minus “-”. Press the 8 key for “-”, press the 2 key for “+”. If single
digits are highlighted, toggle is not possible. In this case, press the CANCEL
TRAILS key to re-highlight the whole indication.
8. Close the menu.
1.15

User Settings

The user functions shown in the table below can be reset to their default settings by
enabling the [PILOT SETTING] option in the [USER SET] menu. Functions not shown
in the table below maintain their previous setting.
The unit can store two separate user settings, for the functions listed below, in the in-
ternal memory. These settings can also be recalled. Functions not shown in the table
below cannot be stored or recalled.
Function
GAIN
SEA
RAIN
TUNE
TX CH
Range
Range rings
VRM1
Setting(s)
Maintained as per
previous setting.
[MAN], the setting
value is maintained
as per previous set-
ting.
[AUTO]
Maintained as per previous setting. (Solid State radars on-
ly)
[6 NM]
[OFF]
Display [ON]
Distance [0.250 NM]
1. OPERATIONAL OVERVIEW
Menu/On-screen box
[GAIN] box
[SEA] box
[RAIN] box
[TUNE] box (Magnetron radars only)
[RANGE] box
[MAIN MENU] [3 NAV TOOLS]
[4 RANGE RINGS]
[VRM1] box
1-23