Display Function - Intellitronix DP1101 Installation Manual

Accessing Functions
When in speed/odometer mode, press and hold the recall button until it starts to run through the
various functions. A quick tap will allow you access to each function. The chart below shows what
each display mode is and how to utilize that function.
Display Function
Hi Spd Displays Highest speed reached
0-60 Displays time to go from 0 to 60 MPH
¼ Displays Time over ¼ mile distance
8 Cylinder Sets cylinder selection
Odo Sets odometer display
Cal Calibrates Speedometer
Trip Distance
A single tap of the recall button will activate the trip meter in the odometer display. A decimal
point will appear which will indicate that you are in trip meter mode. Holding the recall button
will clear out the trip distance. To return to the default odometer display, tap the recall button
again. The decimal point will disappear, indicating that you are back in the default odometer
display.
Setting the Odometer
While scrolling through the functions you will see 'ODO' appear. This will allow you to enter the
vehicle's actual mileage. (Note that this display only allows 5 digits and will 'roll over' at 99,999).
Press the recall button again when 'ODO' is displayed, at this point and you will enter the odometer
set up mode. Press quickly to change the number of the digit on the right. Press and hold to advance
to the next digit. Do this for all 5 digits. For Example: To enter the mileage reading 23456 into the
odometer, at the 'ODO' prompt, tap the small black button (quickly) two times, until the number 2
is displayed. Then press and hold the button until the numbers 2+0 are displayed. Tap the button 3
times until 23 is displayed. Press and hold the button until 230 is displayed and continue in this
manner until 23456 is displayed. The speedometer will advance to the home screen, five seconds
after the last number is entered.
Recording and Viewing Performance Data
Follow these steps to record and recall Performance Data (high speed, ¼mile ET, and 0-60 time):
1. Before each run, your car must be at a complete stop at the starting position. Press
and hold the recall button as it cycles through the performance data. At the end, the
display will reset and all performance data will be cleared. This will not affect your stored
calibration value or the odometer reading.
2. Press the recall button until 'HI-SP' is displayed. The gauge will automatically cycle
through the performance data.
3. Start the run, pass, session, etc., as mentioned above.
4. When finished, repeat Step 2 to view the data gathered from the run. While stopped,
you can view this data as often as you wish. However, once it finishes scrolling one time,
the memory is ready to record new data and will begin recording again once the vehicle
starts to move. The highest speed measured over multiple runs will be retained in
memory.
5 | DP1101 1192024 www.intellitronix.com