Bracket Mounting Kit; Connections At The Instrument - Raytheon ST60 Owner's Handbook Manual

14
6. Screw the two fixing studs (1) into the threaded sockets on the rear
7. Mount the assembled instrument, studs, bezel and gasket into the
8. Locate the flush mount bracket (6) onto the fixing studs and

Bracket Mounting Kit

A Control Unit Mounting Bracket (Part No. E25009) enables you to
mount your ST60 instrument in locations where other forms of
mounting are impractical. Although this provides a useful alternative
method for securing your instrument, it is only suitable for use in
positions where the instrument will not be exposed to water.
To bracket mount your ST60 instrument, do so in accordance with the
Control Unit Mounting Bracket Instruction Sheet.

Connections at the instrument

The connections to the ST60 Club House Wind instrument are shown
in the following illustration.
Flush mounting
of the instrument.
panel.
secure the assembly to the panel with the thumb-nuts (5).
ST60 Club House Wind Instrument Owner's Handbook
1
4
3 1 5 6
D4510-2
5