Surface Mounting - Raytheon ST60 Owner's Handbook Manual

Chapter 2: Installation
ST60 instruments can also be mounted behind a suitably prepared
panel, so that just the instrument dial and keys are visible.

Surface mounting

To surface mount your ST60 instrument (see the Surface mounting
illustration):
1. Ensure that:
• The selected location is clean, smooth and flat.
• There is sufficient space behind the location to accommodate
the rear of the instrument and connectors.
2. Apply the surface mount template (supplied at the rear of this
handbook) to the selected location and mark the centres for the
fixing studs (1) and the aperture (3) that will take the rear casing of
the instrument.
3. Drill out the two 5 mm fixing stud clearance holes (2).
4. Cut out the clearance hole (3) then remove the template.
5. Peel off the protective sheet from the self-adhesive gasket (4) then
stick the gasket into position on the rear of the instrument.
6. Screw the two fixing studs into the threaded sockets on the rear of
the instrument.
7. Mount the assembled instrument, studs, bezel and gasket into the
panel. Secure from behind with the thumb nuts (5).
Surface mounting
4 1 2 1 3
11
5 2 5
D4507-1