Table of Contents
Advertisement
2.5
M.2 Installation
The following instructions are provided using the PPC-415W model for reference:
1.
Follow the procedures in Section 2.3 to open the rear cover and remove the
reinforcement plate.
2.
To install a 22X80mm size M.2 card, insert the M.2 card into the correct main
board slot, and affix it in place using one M3x5L screws provided in the acces-
sory box (see fig. 2.17.1).
3.
To install a 22X42 mm size M.2 card, add a copper cylinder screw (see Fig.
2.17.2) which provided in the accessory box. Then insert the M.2 card into the
correct main board slot, and affix it in place using one M2.5x3L screws.
4.
Add Thermal pad for M.2(see Fig.2.18).
5.
Replace the rear cover and reinforcement plate.
PPC-415W/421W User Manual
Figure 2.18
Figure 2.19 PPC-415W Reinforcement Plate
14
Advertisement
Table of Contents
