Table of Contents
Advertisement
2.4 Hardware Installation
1.
Turn the PC's power off. Turn off the power of any peripheral
devices such as printers and monitors.
2.
Disconnect the power cord and any other cables from the back of
the computer.
3.
Remove the system unit cover (see the users guide for your chassis
if necessary).
4.
Remove the CPU card from the chassis (if necessary) to gain access
to the cards PC/104 connector.
5.
Connect connector J1 of the PCM-3724 card to the PC/104 connec-
tor. Carefully align the pins with the PC/104 connector. Slide the
module into the connector. The module pins may not slide all the
way into the connector; do not force the pins into place, or the mod-
ule may be damaged.
6.
Fasten the module to the CPU card by using the included brass
screw. Screw the brass spacer into the threaded hole on the CPU
card. Do not tighten too much, or the threads may be damaged.
7.
Attach any accessories to the PCM-3724 using 50 pin flat cables.
8.
Reinstall the CPU card and replace the system unit cover. Recon-
nect the cables you removed in step 2. Plug in and turn on the
power. This completes the hardware installation. Install the soft-
ware driver as described in the following section.
13
Chapter 2
Advertisement
Table of Contents
