Receiver Diagnostic Testing - DSC TL280LEX(R) Manual

Event [Section] Label
[838] Delinquency
[840] Event Log 75% full
[842] FTC Restore
[844] Panel Absent Trouble
Restore
[846] Firmware Update
[851] Stay Arm
[853] Night Arm
[855] Activate Command
Output 1
[857] Activate Command
Output 3
[859] Deactivate Command
Output 1
[861] Deactivate Command
Output 3
[863] Bypass
[865] Status Request
[867] Help
[869] Keypad Message
[871] Function Failure
[873] System Stay Armed
[875] System Night Armed
[877] System Disarmed, Not
Ready
[879] Trouble Label
[881] Pay As You Go Balance (Pay as you go balance:)
[883] Response Code

Receiver Diagnostic Testing

[901] Diagnostic Test Transmission
[1] Ethernet 1 Default (OFF).
[2] Ethernet 2 Default (OFF).
[3] Cellular 1 Default (OFF).
[4] Cellular 2 Default (OFF).
[5],[6],[7],[8] Reserved (OFF).
This section may be used by the installer to force the communicator to send an immediate test transmission to specific receiv-
ers, to verify that the communications paths are available. Diagnostic test transmission failure will indicate as FTC trouble
(yellow LED = 9 flashes). If an FTC error occurs when testing all receivers, select only one receiver and repeat test to isolate
the receiver that is not communicating.
NOTE: Sending a test transmission to a receiver that is not programmed generates an FTC trouble.
Default Label
(Delinquency)
(Buffer Near Full)
(fail to communicate
restore)
(Panel Communications
Restore)
(Communicator Firmware
Updated)
(Stay Arm)
(Night Arm)
(Activate Command Output
1)
(Activate Command Output
3)
(Deactivate Command
Output 1)
(Deactivate Command
Output 3)
(Bypass)
(Status Request)
(Help)
(Keypad Message)
(Unsuccessful)
(Stay Armed)
(Night Armed)
(Disarmed Not Ready)
(Service is Required)
(Response Code)
Event [Section] Label
[839] Keypad Lockout
[841] FTC Trouble
[843] Panel Absent Trouble
[845] Module
Reprogramming
[850] Module
[852] Away Arm
[854] Disarm
[856] Activate Command
Output 2
[858] Activate Command
Output 4
[860] Deactivate Command
Output 2
[862] Deactivate Command
Output 4
[864] Unbypass
[866] Alarm Memory Request (Alarm Memory Request)
[868] Pay As You Go Balance
Request
[870] Function Successful
[872] Invalid Command
[874] System Away Armed
[876] System Disarmed
Ready
[878] System In Alarm
[880] No Alarms in Memory
[882] Pay As You Go Message (*123#)
47
Default Label
(Keypad Lockout)
(Fail to communicate trouble)
(Panel Communications
Trouble)
(Communicator
Programming Updated)
(Module)
(Away Arm)
(Disarm)
(Activate Command Output 2)
(Activate Command Output 4)
(Deactivate Command Output
2)
(Deactivate Command Output
4)
(Unbypass)
(Balance Request)
(Successful)
(Invalid Command)
(Away Armed)
(Disarmed Ready)
(is in Alarm)
(No Alarms in Memory)