Lincoln Electric Fleet 650 Service Manual page 72

LINCOLN ELECTRIC
14. Using a 1/2" open-end wrench, attach the lower front panel screw securing the front panel to the
base of the machine.
15. Using a hoist and appropriate rigging attached to the lift bail, lower the machine onto the wood
framing, if necessary.
16. Using a 3/8" nutdriver, attach the two screws and washers securing the mounting bracket to the
wood framing, if necessary.
17. Using a 1/2" nutdriver, attach the four screws securing the front panel to the base of the machine.
18. Using a 1/2" nutdriver, attach the two screws securing the front panel to the shelf.
19. Connect leads 208, 208B and both choke leads to the rear of the negative output terminal. See
Wiring Diagram.
20. Using a 3/4" nutdriver, attach the bolt, lock washer and flat washer, securing the previously
disconnected leads to the rear of the negative output terminal. See Wiring Diagram.
21. Connect lead 206 to the rear of the positive output terminal. See Wiring Diagram.
22. Using a 3/4" nutdriver, attach the bolt, lock washer and flat washer securing the copper bus bar to
the rear of the positive output terminal. See Wiring Diagram.
23. Perform the Case Cover Replacement
24. Perform the Retest After Repair Procedure.
Figure F.33 – Positive and negative output terminal locations
Procedure.
Fleet™ 650 Service Manual
67