Satellite Connection - Beko Crystal 9 B55 OLED D 975 A User Manual

15.Select Satellite Selection using the
and use the
/
you wish to use for searching.
16.Select Scan Mode and use
lect Network or Full.
17.Select Scan Type.
ð Select Only Free Channels for unen-
crypted channels only
ð Select Encrypted Channels Only for
encrypted channels only
ð Select All for all satellite channels.
18.Select Store Type.
ð Select Only Digital Channels for TV
channels only
ð Select Only Radio Channels for radio
channels only
ð Select All for scanning both options.
19.Press the to return to the previous
menu.
20.Select Next option and press the
ð Automatic Search menu will be dis-
played and the search for TV stations
shall start.
ð Search may take several minutes de-
pending on the number of television
stations received.
Note:
• If some of the frequencies are not stored
completely due the changes parameters
satellite parameters made by the broad-
caster, it is recommended to set the
Scan Mode as Network.
21.Press to return to the previous menu,
press to return to TV broadcast or
press to return to Home menu.
to select the satellite
to se-
/
.
20.2 Manual Search for Digital Tele-
vision Channels with Single

Satellite Connection

If a certain channel cannot be found with
automatic scan, scan it by manual scan.
You must enter all parameters of the chan-
nel correctly. You can obtain the current
transponder information from Teletext
page, satellite TV magazines or internet.
If there is a direct cable connection
from your satellite antenna to the
TV set, and if there is no common
satellite antenna switchboard, you
need to search over a single cable.
1. Press the
2. Press the
the .
3. Select Satellite option, and press the
4. Press the
the .
5. Select Channels & Inputs option, and
press .
6. Select Channels option, and press the
.
ð Channel menu will be displayed.
7. Select Satellite option, and press the
8. Select Channel Installation Mode op-
tion, and press the
9. Select Satellite (Standard), or select
Satellite (Operator Mode) if you are us-
ing an operator and press
10.Press the
menu.
11.Select Satellite Manual Tuning option,
and press the
12.Select Current Satellite option, and
press the
ð Satellite Manual Tuning menu will be
displayed.
EN / 92
to switch to the TV mode.
, select Source and press
, select Settings and press
.
.
to return to the previous
.
.
.
.