Table of Contents
Advertisement
Intel(R) Ethernet Controller X550-AT2 for 10GBASE-T -(MAC
address)
Note 1: This feature is available when "Onboard LAN Option ROM Type" is set to EFI.
Note 2: The MAC addresses shown above are based on you system features.
Firmware Image Properties
The following information is displayed:
•
Option ROM Version
•
Unique NVM/EEPROM ID
•
NVM Version
NIC Configuration
Link Speed
Use this feature to set the connection speed of a LAN port specified. The options are Auto
Negotiated, 10 Mbps Half, 10 Mbps Full, 100 Mbps Half, and 100 Mbps Full.
Wake On LAN
Set this feature to support system wake-up via the selected LAN device. If this feature is
set to Enabled, the LAN port selected will be enabled when the system is powered on. The
options are Disabled and Enabled.
Blink LEDs
Use this feature to identify the physical network port by blinking the associated LED. The
default setting is 0 (up to 15 seconds).
The following information is displayed:
•
UEFI Driver
•
Adapter PBA
•
Device Name
•
Chip Type
•
PCI Device ID
•
PCI Address
•
Link Status
149
Chapter 4: UEFI BIOS
Advertisement
Table of Contents
