Supermicro X13DAI-T User Manual page 38

Super X13DAI-T User's Manual
Preparing to Install the PHM into the CPU Socket
After assembling the Processor Heatsink Module (PHM), you are ready to install it into the
CPU socket. To ensure the proper installation, please follow the procedures below.
1. Locate four threaded fasteners (marked a, b, c, d) on the CPU socket.
d
2. Locate four peek nuts (marked A, B, C, D) and four rotating wires (marked 1, 2, 3, 4) on
the heatsink as shown below.
A, B, C, D: Peek Nut
1, 2, 3, 4: Rotating Wire
a, b, c, d: Threaded Fastener
Rotating Wire 2 B
Rotating Wire 4
D
Rotating Wire
Peek Nut
d
(Unlatched)
(Latched)
CPU2 Socket
CPU Socket
c
a
(a, b, c, d: Threaded Fasteners)
4U Heatsink (Top Side)
Rotating Wire
C
Rotating Wire
Pin 1
A
Peek Nut
b
c
a
Pin 1
b
CPU Socket Pin1
Pin 1
Rotating Wire 1 A
3
Rotating Wire 3
C
1
Pin 1
a
c
CPU1 Socket
38
Rotating Wire 4
D
Rotating Wire 2
B
Peek Nut
d
b