Supermicro X13DAI-T User Manual page 148

Super X13DAI-T User's Manual
Supermicro 10GBASE-T Ethernet Controller - (MAC address)
Note: The Ethernet controller and MAC addresses shown above are based on you
system features.
Firmware Image Menu
The following information is displayed:
•
Family Firmware Version
•
Boot Code
•
MBA
•
EFI
•
iSCSI Boot
•
CCM
•
NCSI
•
RDMA FW
Device Configuration Menu
Multi-Function Mode
Use this feature to configure NIC hardware mode. In Single Function (SF) mode, a single
physical function is assigned to each network port. In Network Partitioning Mode (NPAR)
mode, a single physical network port will appear as as multiple virtual network interfaces
in system. The options are SF and NPAR 1.0.
Number of VFs per PF (Available when "SR-IOV" is set to Enabled)
Use this feature to configure the number of Virtual Function (VF) per Physical Function
(PF). The valid range is from 0 to 128 in multiples of 8. Maximum value is 128 divided by
number of ports. The default is 8.
SR-IOV
Use this feature to enable or disable the Single Root I/O Virtualization (SR-IOV) feature on
the network adapter. The options are Disabled and Enabled.
Number of MSI-X Vectors per VF
Use this feature to configure the number of Message Signaled Interrupts (MSI)-X vectors
per VF. The valid range is from 0 to 64. The default is 16.
148