Supermicro X13DAI-T User Manual page 164

Super X13DAI-T User's Manual
Password Check
Select Setup for the system to check for a password at Setup. Select Always for the system
to check for a password at bootup and upon entering the BIOS Setup utility. The options are
Setup and Always.
Hard Drive Security Frozen
Select Enabled to freeze the Lock Security feature for HDD to protect key data in hard drives
from being altered. The options are Enabled and Disabled.
Supermicro Security Erase Configuration (Available when any
storage device is detected by the BIOS)
Note: For more information, please refer to
other/X11_X12_X13_B11_B12_B13_H11_H12_BH12_H13_Secure_Erase_Guide.pdf.
This section allows you to configure the Supermicro-proprietary Security Erase settings. When
this section is selected, the following information is displayed. Please note that the order of
the following information may differ based on the storage devices being detected.
•
HDD Name: This feature displays the name of the storage device that is detected by the
BIOS.
•
HDD Serial Number: This feature displays the serial number of the storage device that is
detected by the BIOS.
•
Security Mode: This feature displays the security mode of the storage device that is de-
tected by the BIOS.
•
Estimated Time: This feature displays the estimate time needed to perform the selected
Security Erase features.
•
HDD User Pwd Status: This feature indicates if a password has been set as a storage
device user password which allows you to configure Supermicro Security Erase settings
on the storage device by using this user password.
•
TCG Device Type: This feature displays the TCG device type detected by the system.
•
Admin Pwd Status: This feature indicates if a password has been set as a storage device
administrator password which allows you to configure Supermicro Security Erase settings
on the storage device by using this administrator password.
Security Function
Select Set Password to set an storage device password which allows you to configure the
security settings of the storage device. Select Security Erase - Password to enter a storage
https://www.supermicro.com/manuals/
164