EMS FIRE SYSTEM 5000 User Manual page 7

E.M.S Group
This indicates that the "Panel
Controls" keyswitch is still in the
ON position. Turn the keyswitch to
the OFF position and remove the key.
The display will change to show,
figure 9
If, while resetting the alarm, the device is still in an alarm state, for example if the Break Glass on a Radio Callpoint has been
broken, the following will occur.
After a short period of time, or after a
key has been pressed, the display will
change to show, figure 11
The Control Panel cannot be reset until the device causing the alarm has been cleared. Once cleared, the Panel can be reset in
the normal way. There may be circumstances under which it might not be possible to clear a device. In such cases, the device
can be temporarily isolated until engineering support is available, by carrying out the procedure detailed in section 8.
After a short while, or after a key has
been pressed, the display will change
to show, figure 8.
If the Alarm Device is still in alarm,
pressing the RESET / LED TEST
button will result in the display
showing, figure 10.
Panel In Access
Date
Figure 8
Status Normal
Date
Figure 9
Device NOT CLEAR :
RADIO CALLPOINT
Push Any Key
Figure 10
01 FIRE ALARM
RADIO CALLPOINT
ZONE 01
Figure 11
6
System 5000
Time
Time
TOT 01
DEVICE 005