E.M.S Group
System 5000
STATUS LAMPS.
There follows a description of the function of each Status Lamp.
FIRE:-This lamp illuminates when a Fire Alarm occurs.
PRE -ALARM:- System 5000 Smoke and Heat Detectors have "built in" intelligence and will, for example, register a sharp
rise in temperature. In such cases a "PRE-ALARM" warning will be given.
TEST MODE:- This Lamp will illuminate when a Detector or Callpoint is put into "TEST MODE". In Test Mode a device
will not activate the sounders.
ISOLATED:- This lamp illuminates when a Detector or Callpoint is isolated. An isolated device will not activate the
Sounders.
SUPPLY HEALTHY:- This lamp illuminates to indicate that the power supply is good.
COMMON FAULT:- This lamp would illuminate should a Control Panel fault condition occur.
PROCESSOR FAULT:- This lamp would illuminate should a Control Panel processor fault condition occur.
DEVICE FAULT:- The Control Panel monitors all devices. This lamp would illuminate should one of the devices, monitored
by the system, develop a fault condition.
KEYSWITCH.
The Keyswitch in the ON position allows limited control of the Panel, without the need for a PIN.
CONTROL BUTTONS.
There follows a description of the function of each control button. Note that the Keyswitch must be in the ON position for the
buttons to function,
SOUND ALARM:- This button is used for activating the System's Sounders.
SILENCE ALARMS:- This button is used to silence the System's Sounders.
RESET / LED TEST:- This button is used to reset an alarm or alarms, after the Silence Alarms button has been pressed.
4