Panel Conditions; Accepting Alarms - EMS FIRE SYSTEM 5000 User Manual

E.M.S Group
6.0

Panel Conditions

Under "Non Alarm" conditions the panel will indicate that the system is clear. The display will show the date and time, as well
as how to gain access to the system. At this time the display will alternate between the two following displays.
Note: If the system has been programmed with the end user, or installation company's name, the screen text may differ
slightly from that shown. The installing engineer can set up an alternative text for the display, should this be required.
When a Fire Alarm occurs ( in this example, it is a Callpoint activation), the front screen text will change, indicating which
device, or devices have signalled and alarm condition (in the example given, it is device N° 005). The Control Panel will
activate the system Sounders and illuminate the applicable flashing Zone Lamp. The display will change to show, figure 5.
7.0

Accepting Alarms

To "accept" the alarm, insert the key into the Panel Controls keyswitch, located at the bottom right of the Panel (figure 2) and
turn the key to the "ON" position.
Press the "Silence Alarms" button and
the display will briefly show, figure 6.
The Control Panel's Internal Bleeper will sound every 3 seconds, to indicate that an alarm condition exists.
Press the RESET/LED TEST button.
The display will indicate the device
has RESET, as shown in figure 7.
Note: A short delay may be present
when resetting devices.
Status Normal
0 for Access
Figure 3
Status Normal
Date
Figure 4
01 FIRE ALARM TOT 01
RADIO CALLPOINT
ZONE 01 DEVICE 005
Figure 5
Figure 6
Figure 7
5
Time
Time
Alarms Silenced
Push Any Key
Device RESET :
RADIO CALLPOINT
Push Any Key
System 5000