Toshiba G9 Installation And Operation Manual page 99

efesotomasyon.com -Toshiba inverter,drive,servo,plc
F040
Automatic Function Selection
Program  Utilities  Display Parameters
This parameter setting is used to configure multiple parameters with the setting
of only one parameter. From the selection below multiple parameters may be
set as indicated in the table.
Once set, the selected configuration is placed in effect and remains in effect
until this parameter is changed or the individual settings are changed.
Set this parameter to Disable to set these parameters individually.
Note: After performing the desired selection the EOI display returns to
Disabled though the selected function has been carried out (i.e.,
without this, if selection 1 is performed,
hold the RR terminal setting regardless of attempts to change the
settings individually).
Settings:
Disabled
RR
V/I
RR or V/I Switched via Terminal Board (ACE G9-120V-PCB)
Keypad Frequency/Terminal Board Command (ACE G9-120V-PCB)
Keypad Frequency and Command
Related Default
0-Disable 1-RR 2-V/I
Params
Settings
Command
Terminal
Mode
Board
F003
Frequency
Mode 1 RR N/C
F004
I3 Terminal Preset
F117 Speed 3
Freq.
Terminal
Priority N/C
Board
F200
V/I
Setup 0.0% N/C
F201
Frequency
Mode 2 V/I N/C
F207
N/C = No Change — the setting remains as it was before setting parameter F040.
Note: *Go to and/or
F003 F004
EOI for control.
ACE-tronics G9 ASD Installation and Operation Manual
F004 and F207
User Settings
4-Keypad/
3-RR or
Freq.
V/I via TB
CMD/TB
Terminal
N/C
Board
RR N/C RR
Freq.
N/C Ref.
Priority
Terminal Board
20.0%
RR V/I
and select EOI Keypad to use the
Direct Access Number — F040
Parameter Type — Selection List
Factory Default — Disabled
Changeable During Run — No
would
5-Keypad
Freq/CMD
*Keypad
*Keypad
N/C
N/C
*Keypad
F040
89