Toshiba G9 Installation And Operation Manual page 202

efesotomasyon.com -Toshiba inverter,drive,servo,plc
F705
Free Unit Display Gradient Characteristic
Program  Utilities  Display Parameters
The ASD-displayed response to output speed changes will be displayed as
directly proportional or inversely proportional as a function of this parameter
setting.
Selecting Negative Gradient displays an increased output speed as going more
negative.
Selecting Positive Gradient displays an increased output speed as going more
positive.
Settings:
Minus (Negative Gradient)
Plus (Positive Gradient)
Free Display Bias
Program  Utilities  Display Parameters
In conjunction with the setting of F702, this parameter sets the bias of the front
panel speed display.
The frequency entered here will be multiplied by the setting of
displayed as the zero value on the front panel screen.
Change Step Selection 1
Program  Utilities  Display Parameters
In conjunction with the parameter setting of F708, this parameter sets the
amount that the output speed will increase or decrease for each speed command
change entered from the front panel using the Rotary Encoder.
Change Step Selection 2
Program  Utilities  Display Parameters
The parameter is used to modify the degree that the setting of
output speed changes that are input from the front panel using the Rotary
Encoder.
Selecting a zero value here disables this parameter and the resulting non-zero
value of parameter setting F707
Selecting a non-zero value here provides a dividend that will be used in the
following equation resulting in the actual output frequency applied to the motor.
Outpu tFrequ enc yDisplay ed
192
F702
F707
is output from the ASD.
= In te rna lly Command edFreque ncy
Direct Access Number — F705
Parameter Type — Selection List
Factory Default — Plus
Changeable During Run — Yes
Direct Access Number — F706
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
and then
Maximum — Max. Freq. (F011)
Units — Hz
Direct Access Number — F707
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — Max. Freq. (F011)
Units — Hz
Direct Access Number — F708
Parameter Type — Numerical
Factory Default — 0 (Disabled)
affects the
Changeable During Run — Yes
Minimum — 0
Maximum — 255
F708
×
------------ -
F707
ACE-tronics G9 ASD Installation and Operation Manual
F708