Toshiba G9 Installation And Operation Manual page 201

efesotomasyon.com -Toshiba inverter,drive,servo,plc
F693
MON 2 Bias Adjustment
Program  Terminal  Analog Output Terminals
This parameter setting is used to ensure that a zero-level input signal produces a
zero-level output at the MON2 terminal.
Set the assigned function of parameter
to a zero output.
See parameter F674 for additional information on this setting.
Parameter Write Lockout
Program  Utilities  Prohibition
This parameter Enables/Disables the Run and Stop keys.
Settings:
Enabled
Disabled
Current/Voltage Units Setup
Program  Utilities  Display Parameters
This parameter sets the unit of measurement for current and voltage values
displayed on the EOI.
Settings:
%
A/V
Free Unit Multiplication Factor
Program  Utilities  Display Parameters
This parameter provides a multiplier for the displayed speed value shown on the
front panel screen of the ASD.
This parameter may be used to display the rate that a commodity is being
processed by the driven load in process units (i.e., units/time).
Example: An output frequency of 100 Hz would be displayed as 50 Hz if
using a multiplier of 0.5 for this parameter.
Note: PID frequency-limiting parameters are not affected by this
setting (i.e., F364, F365, F367, and F368).
Free Unit
Program  Utilities  Display Parameters
This parameter is used in conjunction with
frequency is displayed on the front panel.
The multiplier setting of F702
All Frequencies are selected at this parameter.
The multiplier setting of F702
and F368 ONLY if PID Process Data is selected at this parameter.
Settings:
All Frequencies
PID Process Data
ACE-tronics G9 ASD Installation and Operation Manual
F674 to zero and then set this parameter
F702 to set the method in which the
will be applied to the display of all frequencies if
will be applied to parameters F364, F365, F367,
Direct Access Number — F693
Parameter Type — Numerical
Factory Default — 0.0
Changeable During Run — Yes
Minimum — -10.0
Maximum — 100.0
Units — %
Direct Access Number — F700
Parameter Type — Selection List
Factory Default — Enabled
Changeable During Run — Yes
Direct Access Number — F701
Parameter Type — Selection List
Factory Default — %
Changeable During Run — Yes
Direct Access Number — F702
Parameter Type — Numerical
Factory Default — 0.00 (Off)
Changeable During Run — Yes
Minimum — 0.00
Maximum — 200.00
Direct Access Number — F703
Parameter Type — Selection List
Factory Default — All Frequencies
Changeable During Run — Yes
F703
191