Table of Contents
Advertisement
EN
16
Operation
7. OPERATION
Before using the chainsaw, inspect the work area. This must be cleared. Remove any branches, obstacles and
other items that may cause damage during cutting.
The unit should always be fi lled with fuel and be usable. Check the level of fi lling and refi ll when necessary.
STARTING THE ENGINE
1. Hold the front handle with one hand and take the chainsaw to the ground. Hold the rear handle by stepping
on it.
2. Set the ignition switch to the I position (ON).
3. Press the primer about 4-5 times until fuel appears in the primer.
4. Pull the air damper lever toward you until it locks, the air damper will close.
5. Slowly pull the starter grip until you feel resistance, then pull the cable with a steady movement to a distance
of no more than 50-60 cm. Repeat the procedure several times until the engine starts.
6. Press the throttle lock key and the throttle key, the carburettor air damper will open automatically, the damper
lever will return to its original position.
WARNING! Do not allow the cable to be pulled all the way out before the starter reel has stopped. This will
cause the starter motor to break and is not covered by the warranty.
TO STOP THE ENGINE
1. Release the throttle lock key and throttle key to allow the engine to idle.
2. To stop the engine, move the switch to the O position (OFF).
NOTE: To stop the engine in an emergency, engage the chain brake and move the switch to the "0" position.
CHAIN BRAKE
Starting shall always be done with the chain brake activated. The chain brake is a device that automatically stops
the chain in case a backward movement occurs, causing the saw to jump. Normally, the brake is automatically
activated by the inertia force.
It is also manually tightened by pushing the brake lever down and forward.
When the brake is running, a yellow sign comes out from the base of the brake lever.
To release the brake, pull the brake lever up until it clicks into place.
When the brake is in operation, release the trigger to slow down the engine speed. Continuous use when the
brake is running causes the clutch to heat up and can cause problems.
When checking the machine before using it, check the operating condition of the brake by performing the
following operations:
Start the engine and grasp the handle fi rmly with both hands.
While using the trigger to keep the chain in operation, push the brake lever down with the back of the left
hand.
When the brake is running and the chain is stopped, remove the hand from the throttle.
Loosen the brake.
FZP 45016-B
Advertisement
Table of Contents
