Table of Contents
Advertisement
4.5.2.2 Push the UPS On Switch
will change from figure A to figure G for approximately 15 seconds.
4.5.2.3 Press the UPS On Switch
will be in self-test mode. The UPS may offer energy to the output in a minute, and the LCD displays figure I. In case of failure in pushing
the UPS On Switch for 15 seconds, the UPS will automatically turn off. You must then repeat steps 4.5.2.1 to 4.5.2.3.
G
" Off", which means the UPS pre-start was successful
I
4.5.3 Check Measured Values and Figures detected by the UPS
4.5.3.1 If you would like to check the measured values and figures detected by the UPS use the scroll up
The display sequence are as below figure C ~ P.
I1
Voltage comes from Bypass Input
K
M
O1
P
once for approximately 5 seconds to awaken the UPS. The buzzer will sound twice. The LCD display
again for about three seconds until the LCD display changes from figure G to figure H. Then the UPS
Frequency of Bypass Input
UPS output frequency
UPS battery voltage
UPS inner temperature
H
Utility input is "0" and Utility Abnormal.
J
L
N
O2
9
and scroll down
Frequency of Utility Input
UPS output voltage
UPS output load level (%)
UPS battery numbers
keys.
Advertisement
Table of Contents
