Toro Workman HDX Installation Instructions Manual page 16

Figure 37
1. Stop plate
2. Flange nut (1/2 inch)
4. Close the gap between the dash and cab by
adjusting the tap bolt (1/2 x 4 inches) until the
stop plate pushes upward on the dash
38).
Figure 38
1. Gap between the dash and cab
g246000
3. Adjuster plate
4. Tap bolt (1/2 x 4 inches)
(Figure
g246149
12
Installing the Water Gutter
Parts needed for this procedure:
1 Water gutter
1 Passenger's side clear tube—122 cm (48 inches)
1 Driver's side clear tube—43 cm (17 inches)
1 Floor clear tube—33 cm (13 inches)
1 Tee fitting
3 Magnetic tie-wrap mount
3 Cable tie
Procedure
1. Remove the 5 hex-washer head bolts from the
dash (Figure 39).
Retain the 5 hex-washer head bolts.
1. Dash
2. Slide the water gutter between the machine
dash and sub-frame and secure the water gutter
using the previously removed 5 hex-washer
head bolts (Figure
16
Figure 39
2. Hex-washer head bolt
40).
g245854