Toro Workman HDX Installation Instructions Manual page 18

7. Pinch each end of the clear tube and cut it at a
45° angle (Figure
8. Align the clear tube with the bottom of the water
gutter so that the top of the angle is to the
outside of the machine and install it
1. Tube cut at a 45° angle and installed at the bottom edge of
the water gutter
13
Installing the Floor and
Side-Plate Panels
Parts needed for this procedure:
2 Floor-plate panel
2
Side-plate panel
12 Bolt (1/4 inch)
Procedure
1. Install the floor-plate panels on each side of
the machine using 3 bolts (1/4 inch) as shown
in Figure 45.
1. Bolt (1/4 inch)
44).
(Figure
Figure 44
Figure 45
2. Floor-plate panel
2. Torque the bolts to 1017 to 1243 N∙cm (90 to
110 in-lb).
3. Install the side-plate panels on each side of the
machine using 2 bolts (1/4 inch) as shown in
44).
Figure 46.
g246160
4. Torque the bolts to 1017 to 1243 N∙cm (90 to
110 in-lb).
14
Installing the Center
Console Panel, Seats,
Coolant Tank, CVT-Cooling
Duct (HDX-Auto Machines
only), and Operator's
Manual Tube
Parts needed for this procedure:
2 Bolt (1/4 inch)
2
Spacer
1 Strap
2 Nut (1/4 inch)
1 CVT-intake hood assembly (sold separately)
g026248
Procedure
1. Install the Operator's Manual tube
18
Figure 46
(Figure
g026249
47).