Toro Workman HDX Installation Instructions Manual page 10

6
Installing the Inner Fender
Parts needed for this procedure:
1 Inner fender
2 Fender strap
6 Hex-head flange bolt (1/4 x 3/4 inch)
8 Flange nut (1/4 inch)
2 Rubber bumper
2 Washer
2 Cable tie
Procedure
WARNING
Using a drill without proper eye protection
may allow debris to enter the eye, causing
injury.
When drilling, always wear eye protection.
1. Align the fender straps at the bottom edge of the
seat base frame, and use the fender straps as a
template to mark and drill 3 holes (5/16 inch) on
each side of the seat base frame
Figure 21
1. Fender strap
(Figure 21).
g245709
2. Edge of the seat base
frame
2. Install the inner fender and fenders straps using
6 hex-head flange bolts (1/4 x 3/4 inch) and 6
flange nuts (1/4 inch) as shown in
1. Inner fender
2. Flange nut (1/4 inch)
3. Fold down the flap and tuck the flap behind the
floor flange (Figure
4. Secure the flap with 2 cable ties around the
center frame tube
1. Cable tie
10
Figure
Figure 22
3. Fender strap
4. Hex-head flange bolt (1/4
x 3/4 inch)
23).
(Figure 23).
Figure 23
2. Flap tucked behind the
floor flange
22.
g245710
g245761