Toro Workman HDX Installation Instructions Manual page 5

2. Remove the 4 hex-head screws securing the
shift-indicator cover to the seat shroud
5).
1. Indicator connector
2. Shift-indicator cover
3. Hex-head screws
3. Lift the shift indicator up, disconnect the
indicator connector from the machine harness
connector, and remove the indicator cover from
the machine (Figure
4. Remove the 6 hex-head screws securing the
control cover to the seat shroud, and remove the
control cover (Figure
Removing the Seats
Remove the 8 socket-head bolts securing the seat
rails of the seat to the chassis, and remove the seats
(Figure 6).
1. Socket-head bolts
2. Seat rail
(Figure
Figure 5
4. Control cover
5. Machine harness
connector
5).
5).
Figure 6
3. Seat
3
Removing the CVT Cooling
Duct (HDX-Auto Machines
only), Coolant Tank, ROPS
Assembly, and Seat Shroud
No Parts Required
Removing the CVT Cooling Duct
g024588
For HDX-Auto Machines Only
Remove the hose clamp securing the CVT-cooling
duct to the flange of the CVT intake at the back of the
ROPS panel on the passenger side
1. CVT-intake hose
2. Hose clamp
g023164
5
(Figure 7).
Figure 7
3. Intake-tube connector
g024791