Toro Workman HDX Installation Instructions Manual page 14

Figure 31
1. Lifting points
6. Secure the frame to the machine using the 4
bolts (1/2 inch), 4 washers (1/2 inch), and 4 nuts
(1/2 inch) as shown in
Note:
Do not tighten the 4 bolts (1/2 inch).
Figure 32
7. Adjust the cab from side to side to ensure that
the cab is centered.
Use the adjuster bolt
cab.
8. Torque the 4 bolts (1/2 inch) to 91 to 113 N∙m
(67 to 83 ft-lb).
Figure 32.
(Figure 26) to center the
10
Routing the Wire Harness
Parts needed for this procedure:
1 Wire harness
4 Cable ties
1 Fuse (30 A)
Procedure
g026247
1. Route the wire harness as shown in
and secure it with the 4 cable ties.
2. Connect the ring terminal on the harness to
the grounding block and insert the fuse-block
connector into an available fuse-block
connection
Note:
If there is not an available fuse-block
connection, you must add a fuse block to the
g026272
fuse-block grouping. Contact your Authorized
Service Dealer for more information.
14
Figure 33
(Figure 34).
Figure 33
g026273