Installation; Loose Parts; Preparing The Machine - Toro 07324 Installation Instructions Manual

Installation

Loose Parts

Use the chart below to verify that all parts have been shipped.
Description
No parts required
Rear support tube
Left, rear support bracket
Right, rear support bracket
Bolt (5/16 x 2-3/4 inches)
Bolt (5/16 x 2 inches)
Bolt (5/16 x 1-3/4 inches)
Flat washer (5/16 inch)
Flange nut (5/16 inch)
Bolt (5/16 x 1 inch)
Right dash-support bracket
Carriage bolt (5/16 x 3/4 inch)
Flat washer (3/8 inch)
Bolt (3/8 x 1 inch)—machines with ROPS only
Clinch nuts—machines with ROPS only
Hex-socket button head screw (5/16 x 2
inches)—2016 and after models only
Spacer—2016 and after models only
Flat washer (11/32 inch)—2016 and after
models only
Locknut (5/16 inch)—2016 and after models
only

Preparing the Machine

1. Park the machine on a level surface.
2. Engage the parking brake.
3. Shut off the engine and remove the key from the key switch.
Qty.
–
Prepare the machine.
1
1
1
8
2
4
10
25
10
1
Install the canopy.
2
2
2
2
1
1
1
1
Figure 1
3
Use
g038494