Jacking Up The Machine - Toro Workman HDX Installation Instructions Manual

For Workman HDX-Auto machines:
1. Unplug the shift-indicator connector from the
machine harness
1. Shift-indicator connector
2. Lift and rotate the center control assembly out
of the way to gain access to the suspension
springs.
Both machines:
Lift the seat shroud and remove it from the machine
(Figure 13).
(Figure 12).
Figure 12
2. Machine harness
Figure 13
For Workman HDX-Auto machines:
Remove the bolts securing the lift valve to the controls
bracket, and the nuts and bolts securing the control
bracket to the machine
g025506
1. Bolts securing the control
bracket to the machine
2. Bolts securing the lift valve
to the controls bracket
4

Jacking Up the Machine

and Removing the Front
Wheels
No Parts Required
Jacking Up the Machine
DANGER
A machine on a jack may be unstable and slip
off the jack, injuring anyone beneath it.
• Do not start the machine while the machine
is on a jack, because the engine vibration
g026471
or wheel movement could cause the
machine to slip off the jack.
• Always remove the key from the switch
before leaving the machine.
• Chock the tires when the machine is on a
jack.
• Do not work under the machine without
jack stands supporting it. The machine
could slip off a jack, injuring any one
beneath it.
7
(Figure 14).
Figure 14
3. Bolts securing the control
bracket to the machine
4. Nuts
g027095