Toro Workman HDX Installation Instructions Manual page 19

Figure 47
1. CVT-intake hood
assembly (Workman
HDX-Auto machines
only—kit sold separately)
2. Nut
3. Spacer
2. Align the holes in the seat rails with the holes
in the shroud for the seat mounting positions
(Figure 6).
3. Secure the seats to the chassis with the 8
socket-head bolts
in step Removing the Seats (page
4. Secure the CVT-cooling duct
intake-tube connector using the hose clamp that
you removed in 3 Removing the CVT Cooling
Duct (HDX-Auto Machines only), Coolant Tank,
ROPS Assembly, and Seat Shroud (page
Important:
This step applies to Workman
HDX-Auto machines only.
Note:
You must add the CVT-intake hood
assembly to this kit for Workman HDX-Auto
machines. See your Authorized Service Dealer.
5. Align the center console panel over the control
rods at the center console
5) and secure the panel with the screws that
you removed in 2 Removing the Center Console
Panel and Seats (page
6. Install the knobs you removed in
the Center Console Panel and Seats (page
7. Align the left and right flanges of the coolant-tank
bracket with the coolant tank support on the seat
shroud (Figure 8).
8. Lower the tank into the support until the tank is
firmly seated (Figure
4. R-clamp
5. Plate
6. Bolt
(Figure 6) that you removed
5).
(Figure 7) to the
(Figure 3 and
3).
2 Removing
8).
15
Connecting the Battery,
Lowering the Bed, and
Installing the Hood
No Parts Required
Procedure
Refer to the Operator's Manual for the machine.
g026275
1. Connect the positive battery cable to the battery.
2. Squeeze the battery cover, align the tabs to
battery base, and release battery cover.
Note:
machine.
3. Lower the bed; refer to the Operator's Manual.
4. Align the bottom of the hood to the top of the
bumper.
5. Connect the lights.
6. Insert the top mounting tabs into the frame slots.
7. Insert the lower mounting tabs into the pockets
in the bumper.
8. Ensure that the hood is fully engaged in the top,
sides, and bottom grooves.
5).
Figure
3).
19
Refer to the Operator's Manual for the