Toro Workman HDX Installation Instructions Manual page 6

Removing the Coolant Tank
1. Lift the coolant tank up and out of the support
pocket on the back of the seat shroud
1. Coolant tank
2. Coolant-tank bracket
2. Set the coolant tank upright onto the
engine/chassis.
Removing the ROPS Assembly
1. Remove the 6 bolts securing the ROPS
assembly to the frame of the machine as shown
in Figure 9 and Figure
Note:
Do not discard the bolts.
2. Remove the Operator's Manual tube and
R-clamps from the ROPS assembly and set it
aside.
(Figure
Figure 8
3. Seat shroud
10.
Figure 9
8).
g023166
Removing the Seat Shroud
For Workman HDX machines:
1. Engage the parking brake
1. Gear-selector boot
2. Gear-selector rod
3. Parking brake
2. Move the differential-lock rod forward and to the
right to lock it in the engaged position
g026469
11).
6
Figure 10
(Figure 11).
Figure 11
4. Differential-lock rod
5. Hydraulic-bed lift rod
6. High-low range shifter rod
(Figure
g026470
g023171