Tig Setup Menu; Accessing The Tig Setup Menu; Changing Welding Parameters; Exiting The Tig Setup Menu - Fronius TransTig 1750 Puls Operating Instructions Manual

TIG setup menu

Accessing the
TIG setup menu
Changing weld-
ing parameters
Exiting the TIG
setup menu
Welding parame-
SPt
ters in the TIG set-
Spot welding time
up menu
Unit
Setting range
Factory settings
If a value has been set for the SPt setup parameter, the operating mode 2-step mode will
have the function of the spot welding mode.
The special spot welding indicator on the control panel remains lit as long as a value has
been specified for the spot welding time.
tAC
Tacking function when TIG DC welding is selected: Duration of the pulsed welding current
at the start of tacking
Unit
Setting range
68
Press the Mode button to select 2-step mode or 4-step mode
1
Press and hold the Mode button
2
Press the Parameter Selection button (right)
3
The power source is now in the TIG setup menu. The last welding pa-
rameter selected is displayed.
Use the left or right Parameter Selection button to select the param-
1
eter that you want to change
Use the adjusting dial to change the parameter value
2
Press the Mode button
1
s
OFF / 0.05 - 25.0
OFF
s
OFF / 0.1 - 9.9 / ON