Preparations; Tig Welding - Fronius TransTig 1750 Puls Operating Instructions Manual

Unit
Setting range
Factory settings
IMPORTANT! The downslope t
Unit
Setting range
Factory settings
Unit
Setting range
Factory settings

Preparations

1
Risk of injury and damage from electric shock.
As soon as the mains switch is in the "I" position, the tungsten electrode of the welding
torch is LIVE. Make sure that the tungsten electrode does not touch any persons or elec-
trically conductive or earthed parts (e.g. housing, etc.).
2
All the indicators on the control panel light up briefly.

TIG welding

1
2
3
4
Downslope t
down
s
0.01 - 9.9
1.0
End current I
E
% (of main current I
0 - 100
30
Electrode diameter
mm
OFF / 0.1 - 3.2
2.4
Plug in the mains plug
CAUTION!
Turn the mains switch to the "I" position
Press the Mode button to select the required TIG mode:
2-step mode
4-step mode
Use the left or right Parameter Selection button to select the relevant parameters in
the welding parameters overview
Use the adjusting dial to set the selected welding parameters to the desired value
All parameter set values that were set using the adjusting dial will remain stored until
they are changed. This applies even if the power source is switched off and on again
in the meantime.
Open the gas cylinder valve
is saved separately for 2-step and 4-step modes.
down
)
1
51