Table of Contents
Advertisement
Chapter 2 NAME OF PARTS
No.
Name
9
Buzzer stop switch
10
Illumination switch
11
Engine stop button
12
Starter switch
Warning light
Water temperature warning light
(coolant temperature rise warning
light)
13
The light comes on when the coolant
(fresh water) temperature rises abnor-
mally. If this light comes on, run the
engine at no load minimum idling speed,
and then stop the engine. Check the
cooling system after the engine has
cooled down.
(Temperature at which thermo switch
turns ON: 88°C [190?F])
Note: The warning buzzer will goes off
when the oil pressure warning light
or water temperature warning light
comes on.
2-8
Table 2-1 Instrument Panel
When the warning buzzer goes off, turn this switch "OFF" to stop the buzzer. Always
keep this switch in "ON" position during operation.
Turn this switch "ON" to illuminate gauges.
Press this button to stop the engine. When the button is pressed, stop solenoid will
be energized for about ten seconds. During this period, the engine cannot be
restarted.
OFF (Switch Off):
Return the key to OFF position when the engine is stopped.
The key can be removed or inserted in this position since elec-
trical circuits of gauges are disconnected.
ON (Switch ON):
Place the key in this position after the engine has started (dur-
ing operation). Electricity flows through the electrical circuits of
gauges and warming indicators/lamps.
START (Start-up):
Turn the key to "START" position to start the engine. Release
your hand from the key when the engine has started. The key
returns to "ON" position automatically.
Function
Filter warning light (oil filter clogging warning light)
Not used in this specification.
Charge warning light (battery charge fault light)
The light comes on when there is a fault in charging sys-
tem. Check the charging system when the light comes
on.
Note: Note that this light illuminates for several seconds
immediately after starting the engine.
Oil pressure warning light (lubricating oil pressure
drop warning light)
The light comes one when the lubricating oil (engine oil)
pressure drops abnormally. Stop the engine at once, and
check the lubricating system.
(Oil pressure that triggers the switch: 0.25 MPa
{2.5 kgf/cm
2
}[36.3 psi] ))
Advertisement
Table of Contents
Troubleshooting
