Table of Contents
Advertisement
Chapter 3 OPERATION
Warning Indicator Light - Operation Check
1. Turn the starter switch to the "ON" position.
2. Turn the light test switch to "ON" position.
3. Make sure the lights come on. If any of the lights
does not come on, check the light bulbs, etc. on the
instrument panel.
Control Cable - Check
Check the visual appearance of control cable for flaw,
deformation, discoloration, abnormal rust, etc.
Control Lever - Operation Check
Operate each lever and make sure that levers move
smoothly without any looseness or restriction.
Operate the speed control lever from L (low-speed
rotation) to H (high-speed rotation) and to L (low-
speed rotation) position to make sure the operation of
lever.
Operate the direction lever, and make sure the posi-
tion of marine gear for "Forward", "Neutral," and
"Reverse."
3-14
kg/cm
2
kg/cm
2
Fig. 3-20 Warning Indicator Light - Operation Check
X100RPM
OFF
HEAT
ON
START
ON
STARTER SWI T CH
OFF
Advertisement
Table of Contents
Troubleshooting
