3.1.2 Power On - Mitsubishi Electric FR-E560 Series Instruction Manual

(5) Communication operation mode
(Pr. 79 "operation mode selection" = 0 or 1)
Communication operation can be performed by connecting a personal computer and
the PU connector with the RS-485 communication cable.
Preparation
• Connection cable......................Connector: RJ45 connector
• Personal computer ...................Refer to the instruction manual of the inverter setup
• RS-485, RS-232C converter ....To be prepared when the communication port of the

3.1.2 Power on

Before switching power on, check the following.
Installation check
Make sure that the inverter is installed correctly in a proper location. (Refer to page
14.)
Wiring check
Make sure that the main and control circuits are wired correctly.
Make sure that the options and peripheral devices are selected and connected
correctly. (Refer to page 16.)
Switch power on.
Power-on is complete if the POWER lamp is lit to give a correct indication and the
ALARM lamp is off.
Cable: Cable conforming to EIA568
(e.g. 10BASE-T cable)
software for hardware requirements of the inverter
setup software.
personal computer has RS-232C specifications.
50
OPERATION/CONTROL