Mitsubishi Electric FR-E560 Series Instruction Manual page 64

(1) Example:To change the Pr. 79 "operation mode selection" setting
from "2" (external operation mode) to "1" (PU operation mode)
(For details of Pr. 79, refer to page 113.)
Press the key, to choose the
MODE
parameter setting mode.
Parameter setting mode
PU
MODE SET REV
STOP
FWD
RESET
MODE
To 3.2.6 Operation mode
Current setting
SET
Flicker
Most significant
digit flickers
SET
Setting change
Press for
1.5s
SET
Setting write
When
1) If the RUN indication is lit or flickering,
2) You cannot set any value that is outside the
"1" (PU operation mode) has been set in Pr. 79.
If the value and
for 1.5s when writing the value.
Press the
restart the setting from the beginning.
54
OPERATION/CONTROL
Middle digit flickers
SET
× 7 times
or
× 3 times
0 to 9
appears
stop operation by pressing the
key or turning off the forward rotation
(STF) or reverse rotation (STR) signal
connected to the control terminal.
parameter setting range. Write a value within
the setting range.
appears, you did not press the
key once, press the
Least significant
digit flickers
× 9 times
or
× 1 time
SET
0 to 9
RUN
STOP
RESET
do not flicker but
key
SET
key, and
SET