Mitsubishi Electric FR-E560 Series Instruction Manual page 171

(3) Read Pr. 903 and show the current setting of the gain frequency.
(Pr. 902, Pr. 904 and Pr. 905 can also be adjusted similarly.)
Parameter setting mode
Using the
"parameter setting mode" as in (2)-1).
MODE
FWD
Most significant
digit flickers.
Current setting of gain frequency
(4) Set a gain frequency in Pr. 903 and show the analog voltage value across
terminals 2-5 in % (when the frequency is set to 80Hz)
Current setting of
gain frequency
key, choose the
MODE
Hz RUN
A MON
PU EXT
SET REV
STOP
RESET
SET
Middle digit
flickers.
9 times
SET
0 to 9
Hz RUN
A
PU
EXT
Changing the gain
frequency
Hz
RUN
A
PU EXT
Press
the set frequency.
Press for 1.5s
Analog voltage value (%)
across terminals 2-5
In any of the methods in (5)-1) to (5)-3) on the following
page, continue the setting until the analog voltage value
flickers. If you end the setting here, the gain frequency
change will not be reflected.
161
Least significant
digit flickers.
SET
3 times
0 to 9
Hz
RUN
A MON
PU EXT
to change
SET
Hz RUN
A MON
PU EXT
PARAMETERS
SET
4